Extrudr Filament Green-TEC Anthracite 3mm 1.1Kg

Green-TEC Filament

Biocompounds (BDP) is produced almost 100% from renewable and natural raw materials.
The raw materials are CO2-neutral and ecologically absolutely harmless. The new biomaterials are a non-toxic alternative to conventional ABS, PETG or PLA filaments and are even superior to them in terms of temperature resistance, hardness and elongation. The material properties also surpass the established 3D printing materials in terms of shrinking and warping. It is therefore suitable for complicated and especially large print objects. The printer does not need a heating bed.

Application: High-performance application in the technical field as well as biological alternative to ABS & PETG. Very high temperature resistance.
Regulation: The biopolymer complies with all regulations of the European Food Contact Regulation.

Properties

• Temperature resistant up to 110 degrees - 120 degrees

Very low warping (<0.5%)

High mechanical resistance resulting in lighter components

Food safe
Odourless

High layer adhesion and good optical properties

Biodegradable

3D printing settings

Max pressure in mm/s 120
Minimum hotend temperature: 200 degrees
Maximum hotend temperature: 230 degrees
Recommended hotend temperature: 215 degrees
Nozzle material: All
Nozzle diameter: 0.25-1.2mm

First recommendation

Heating bed: 35-50 degrees
Adhesion with adhesive spray

Second recommendation

Without heating bed
Adhesion with Blue Tape

Technical data

Heat resistance: 110 degrees

Diameter
Our filament is high quality and has very low tolerances.

Typical guide values:

Diameter: 2.85mm

Tolerance: +/- 0.05mm

Coil size:

Diameter outside: 20cm

Width: 6.2cm

Diameter inside (hole): 5.2cm.